Pulsar by DAB is a 5-inch multi stage impeller single block submersible pump. Designed to increase water pressure, gardening and irrigation and water drawing from the underground in residential building service. These pumps can operate immersed in wells (of at least 5") and first collection tanks or cisterns and can increase the water pressure. Suction takes place through a filter located in the lower part of the pump. The motor of the Pulsar pump is located above the hydraulic part and is cooled by the pumped liquid. Robust components allow the pump to run dry for short periods. Impellers and diffusers are made in technopolymer. 15-meter power cable, thermoamperometric protection and starting capacitor included in the single-phase version. The single-phase version is also available without the capacitor, this version must be combined with a control panel supplied as an accessory. Protection by the user in the three-phase version.
Flow rate maximum: From 0,9 m3/h a 7,2 m3/h
Head up to: 88 m
Maximum immersion depth: 20 m (12 meters on the plate for 15m cable length)
Type of pumped liquid: Clean, free from solid or abrasive substances, non-viscous, non-aggressive, non-crystallized and chemically neutral
Sand quantity: 50 g/m3
Liquid temperature range: From 0°C to +40°C
Thread: 1" 1/4 GAS
Pump maximum diameter: 138 mm
Impeller/s material: Technopolymer
Maximum number of starts: 20/h
Non-stop service: IP 68
Protection class: F
Motor insulation class: 230 V 50 Hz
Power cable (m) and plug: 3x230 V 50 Hz / 3x400 V 50 Hz
Single phase power input: 15 m H07RN-F
Possible type of installation: Fixed or removable, in vertical or horizontal position
Special versions on request: Different voltages and frequencies, different cable length
Certification: CB report is available
