The pump is not sucking

• No water in the pre-filter or clogged pre-filter
• Close valve in the pipes
• Air getting into the suction pipe

Noisy pump

• Air getting into the suction pipe
• Presence of foreign bodies in the pump body
• Cavitation

Periodically inspect and clean the pump filter:

The pump is equipped with a filter that must be cleaned periodically, without pouring disinfectants and chemicals directly into the pump.
We recommend you read the instruction manual of the Europro (also available in our DNA software) which contains all the necessary information.

Installation, electrical connection and commissioning must be carried out by skilled personnel in compliance with the general and local safety regulations in force. Failure to comply with these instructions not only causes risk to personal safety and damage to the equipment, but invalidates every right to assistance under guarantee.
We recommend you read the instruction manual of the Europro (also available in our DNA software) which contains useful information for the the use of the product. For the three-phase pump, follow the wiring diagrams:

We recommend making a good earth connection and placing the electric pump as close as possible to the liquid to be pumped. With this pump it is necessary to install a foot valve on the suction side.

For three-phase motors check the correct direction of rotation of the motor which must be clockwise. Otherwise invert any two phase leads, after having disconnected the pump from the power mains.

In the case of electropumps without a cable, provide power cables type H05 RN-F for internal use and type H07 RN-F for external use, complete with plug (EN 60335-2-41).
We recommend you read the instruction manual of the Europro (also available in our DNA software) which contains all the relevant information.